Publicidad
Idiomas disponibles
Idiomas disponibles
A(mm)
B(mm)
760
50 mini
Before you install the hob, make sure that
the work surface is square and level, and no structural members interfere with space
•
requirements.
the work surface is made of a heat-resistant material.
•
if the hob is installed above an oven, the oven has a built-in cooling fan.
•
the installation will comply with all clearance requirements and applicable standards
•
and regulations.
a suitable isolating switch providing full disconnection from the mains power
•
supply is incorporated in the permanent wiring, mounted and positioned to comply
with the local wiring rules and regulations.
•
The isolating switch must be of an approved type and provide a 3mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules
allow for this variation of the requirements).
the isolating switch will be easily accessible to the customer with the hob installed
•
you consult local building authorities and by-laws if in doubt regarding installation
•
you use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
•
surfaces surrounding the hob.
When you have installed the hob, make sure that
The power supply cable is not accessible through cupboard doors or drawers.
•
•
There is adequate flow of air from outside the cabinetry to the base of the hob.
•
If the hob is installed above a drawer or cupboard space, a thermal protection barrier
is installed below the base of the hob.
The isolating switch is easily accessible by the customer.
•
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply
force onto the controls protruding from the hob.
Locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not
•
apply force onto the controls protruding from the hob.
Fix the hob on the work surface by screw four brackets on the bottom of hob (see
•
picture) after installation.
Adjust the bracket position to suit for different work surface's thickness.
•
C(mm)
D
20 mini
Air intake
24
E
Air exit 5mm
Publicidad
