Clean The Rolling Brush; Clean The Sensors And Charging Pins; Clean The Side Brushes - EUFY RoboVac R550C Manual Del Propietário

English
Push the dust collector back into the main unit.
- It is recommended to empty the dust collector and clean the filter after every use.
- You can wash the dust collector, pre-filter and foam filter with water. Be sure to air-
dry them thoroughly before reassembling. Do not wash the high-performance filter
with water, as it may damage the filter and reduce the suction power.

Clean the Rolling Brush

Pull on the release tabs to unlock the brush guard as shown.
Lift the rolling brush to remove.
Clean the rolling brush with the provided cleaning tool or a vacuum cleaner.
Reinstall the rolling brush by inserting the fixed protruding end first and then clicking
into place.
Press down to snap the brush guard into place.
1 2
4 5
20
3

Clean the Sensors and Charging Pins

To maintain the best performance, clean the drop sensors and charging pins regularly.
• Dust off the drop sensors and charging contact pins using a cloth or cleaning brush.

Clean the Side Brushes

Foreign substances, such as hair, can easily get tangled in the side brushes, and dirt may
adhere to them. Be sure to clean them regularly.
Carefully unwind and pull off any hair or string that is wrapped between the main unit
and the side brushes.
Use a cloth dampened with warm water to remove dust from the brushes or to gently
reshape them.
Use the side brushes only when they are completely dry.
English
21