•
To set the product in mow position, set the
correct cutting height. Refer to
height on page 14 .
To set the cutting height
•
Pull the lift lever in the direction of the seat and
put it in 1 of the notches for the correct cutting
height.
To move forward and rearward
The direction and speed of movement is controlled
by the forward and reverse drive pedals.
1. Start the engine.
2. Disengage the parking brake. Refer to
engage and disengage the parking brake on
page 14 .
3. To start movement, slowly push down on the
forward drive pedal (A) or the reverse drive pedal
(B).
Note:
The forward and reverse drive pedals
go back to neutral position when they are not
pushed down.
4. Push down more on the forward drive pedal or
the reverse drive pedal to increase the speed.
14
To set the cutting
To
A
B
To engage and disengage the
parking brake
1. To engage the parking brake, push down the
brake pedal (A) fully to the lowest position.
A
2. With the brake pedal pushed down, pull up the
parking brake lever (B).
3. Release the brake pedal.
4. Release the parking brake lever.
Note:
Make sure that the parking brake holds
the product safely.
5. To release the parking brake, push down the
brake pedal.
To stop the product
WARNING:
product, engage the parking brake and
remove the ignition key before you go
away from the product.
CAUTION:
the warm engine can cause burn
damage to the grass. To prevent burn
damage , to the grass, always stop the
engine when you stop the product on
grass areas.
1. Push down on the brake pedal (A) fully until the
product stops fully.
2. Disengage the cutting deck. Refer to
and disengage the cutting deck on page 15 .
3. Put the throttle control in the slow position and
let the engine operate at idle speed for some
minutes.
B
Always stop the
The exhaust gas from
A
To engage
1963 - 002 - 13.10.2022