cecotec BOLERO WASH&DRY 8580 INVERTER B Manual De Instrucciones página 123

Cleaning the drain pump filter
WARNING: DANGER OF BURNS. Danger of skin injury from hot water!
Take special care when draining water from the appliance and opening the lid.
It is advisable to clean the filter of the drain pump from time to time to ensure that there
are no problems.
The pump of the appliance may become blocked with loose debris (remember to check the
drum and remove visible debris after each load). Fabrics that shed large amounts of lint
can also cause blockages.
To access the drain pump filter, you must first open the cover on the bottom right-hand
side. Press lightly to open the lid (Fig. 23). With the lid open, proceed as follows:
1. If the appliance has not been drained, try draining it now. First, turn the wash cycle
selector to select the SPIN programme, press the SPEED button until the display shows
"-", then press the START/PAUSE button. Wait a moment for the pump to drain the
water from the drum. If the pump is totally blocked, the water will not be able to drain,
and the cycle will end.
2. Turn off the tap so that no more water enters. Turn off the appliance. Disconnect the
power cord from the plug.
3. Use the removable drain hose (depending on the models) located on the filter access
opening to drain the remaining water into a suitable container (up to 20 litres of water
can be drained). Remove the plug from the hose and place it over the side of a suitable
container and allow the water to drain out of the drum. When finished, replace the
sealing plug on the end of the hose and return the hose to its storage location. Be
careful not to spill the drained water on the floor (Fig. 24).
4. Turn the filter cover counterclockwise to remove the filter. A small amount of residual
water may flow out when the lid is removed. Clean the inside, as well as the filter itself,
removing any debris or foreign objects. Remove any lint, dirt or detergent residue from
the filter thread. You can use water, a cloth or a soft brush. Reinstall it in its original
position (Fig. 25).
5. Close the lid and wipe up any water spillage (Fig. 26).
02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 123 02770/71_BOLERO WASH&DRY 8580 INVERTER B/ INVERTER STEEL B_RP_01230629.indd 123
BOLERO WASH&DRY 8580 INVERTER B/STEEL B
ENGLISH
123
29/6/23 16:38 29/6/23 16:38