Publicidad
STEP 7
Attach each side mounting bracket
to the inside of the face frame
using the (6) provided #6 x 5/8"
flat head screws (See Fig 7).
#2
STEP 8
Re-engage the unit into each of
the cabinet members, ensuring the
slides are aligned properly
(See Fig 8). Once engaged, fully
cycle the unit a few times to ensure
proper slide operation.
STEP 9
Re-install the gas spring while
making sure that the gas reservoir
is attached to the top stud as
shown in Fig 9. Make sure to install
both of the retainer clips into each
of the stud caps.
STEP 10
At this time, proceed to page 8
and continue your installation.
4
Retainer Clip
Customer Service: 800-626-1126 | rev-a-shelf.com
FIGURE 7
FIGURE 8
RE-ENGAGE UNIT
FIGURE 9
Publicidad
