Dreame H14 Manual Del Usuario página 10

Care & Maintenance
EN
Cleaning the Brush Assembly
1. Press the brush roller cover release
buttons to remove the brush roller cover.
3. Clear any hair and debris caught
on the brush roller with the provided
cleaning brush. Rinse the brush roller
and the cover with clean water and dry it
completely.
5. Re-install the brush roller and the
brush roller cover until you hear a click.
Note:
• Do not rinse the brush assembly with water.
• Clean as needed. Replacing the brush roller every 3 to 6 months is recommended.
• Ensure the Used Water Tank is removed or empty before laying the appliance on its side to clean the roller brush.
14
2. Press the brush roller release
button and pull the handle to take out
the brush roller.
1
2
4. Wipe the suction inlet with a dry cloth
or wet tissue.
Troubleshooting
If an error occurs, the appliance will stop working. Please refer to the following table for
troubleshooting. If the problem persists, please contact the customer service.
Error Possible Cause
The appliance is out of battery or its
battery level is low.
The appliance is in the upright
position.
The appliance Blockage activated overheat
does not work. protection mode.
The Used Water Tank is full.
The parts are not installed in place.
The appliance The temperature of the battery is
charges slowly. too low or too high.
The filter is clogged.
The suction power
of the appliance is
weak. The suction inlet or tube is blocked
by a foreign object.
There is too much dirty water in the
Used Water Tank.
The motor is
making a strange
noise.
The suction inlet is blocked.
The charging base plug is not
inserted into the electrical outlet
The battery level
properly.
indicator on the
display screen
does not light up
The appliance is not placed onto
while charging.
the charging base properly.
The Clean Water Tank is
not properly installed in place, or
the water in the Clean Water Tank is
No water is
insufficient.
coming out
of the appliance.
It takes 30 seconds to dampen the
brush roller.
EN
Solution
Fully charge its battery before
use.
Recline the appliance
backwards.
Clear the blockage and wait
until the temperature returns
normal.
Empty the Used Water Tank.
Ensure all parts are all properly
in place.
Wait until the battery's
temperature returns normal.
Clean the filter.
Clean the tube and the suction
inlet.
Empty the Used Water Tank.
Clear any blockage in the
suction inlet.
Make sure the charging base
plug is inserted in place.
Make sure the appliance is
placed onto the charging base
properly.
Re-install or fill the Clean Water
Tank.
Turn on the appliance and check
again after a while.
15