Laica DUAL FLO 3KW KJ2001W Manual De Usuario página 7

DO NOT fill past the MAX level indicated on the Water Level Window. Overfilling may cause water to
dispense or spit out of lid when boiling.
3. Close the Lid.
4. Place the Kettle on the Power Base on a flat, level, dry, heat resistant surface. Ensure that it is correctly
engaged on the Power Base.
5. Plug into a 220v - 240v AC wall outlet.
NOTE: Never plug kettle into an electrical outlet when the kettle is empty.
6. Direct kettle spout away from cabinets, walls, etc. to prevent possible steam damage.
7. Depress the Power Button on the Lid and the white indicator light will be visible through the Water Level
Window indicating that the kettle is in the boil cycle. Once the water has boiled, the indicator light will go
out and the Kettle will shut off. To turn off the kettle at any time, press the Stop Button.
IMPORTANT:
a) The kettle shuts off automatically after the boiling cycle is complete.
b) If the kettle is removed from the Power Base before the boiling cycle is complete kettle will
automatically shut off.
c) To turn the kettle off before the boiling cycle is complete, press the Stop Button.
8. The Lid should not be opened when the Kettle is hot.
9. If you want to use the Kettle again, allow the thermal safety switch to cool down for 15 to 20 seconds then
depress Power Button.
10. Return the Kettle to the Power Base or a heat resistant surface after use.
11. IMPORTANT: If the Kettle is accidently switched on when empty, the thermostat will automatically cycle on
and off to prevent the Kettle from overheating. If this situation occurs, press the Stop Button and unplug
the Kettle immediately. Let the Kettle cool before refilling.
12. It is recommended that the Power Cord be disconnected from the wall outlet when not in use.
13. DO NOT attempt to connect any other appliance to the Power Base or tamper with the connector in
any way.
WATER DISPENSER MODE
1. Follow steps 1-6 in the HOW TO USE section.
2. Ensure Drip Tray is in position and open the Water Dispensing Port by pressing the Water Dispensing Port
Opening Button.
3. Place a mug on Drip Tray. IMPORTANT NOTE: A mug must ALWAYS be placed on the Drip Tray when
Water Dispensing Port is open.
4. Select your desired cup size by turning the dial around the Power Button, and Press the Power Button
(Minimum 150ml, middle 200ml, maximum 250ml).
5. When water has boiled it will automatically pour into the mug from the Water Dispensing Port and the
kettle will shut off.
IMPORTANT:
a) The kettle shuts off automatically after the boiling cycle is complete.
b) If the kettle is removed from the Power Base before the boiling cycle is complete the kettle will
automatically shut off.
c) To turn the kettle off before the boiling cycle is complete, press the Stop Button.
5