Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL
REMOTE FUNCTIONS
1. Press
to power on.
2. Select desired fan speed setting by pressing +/- button.
3. Press
to activate timer.
4. To adjust timer setting, press
5. To cancel timer, cycle through the timer settings or press and hold
timer button until off.
6. Press
to turn Oscillation on and off.
TIMER
POWER ON/OFF
SPEED / TIMER ADJUSTMENT (-/+)
OSCILLATION
Note: The remote requires a line-of-sight
path to allow for the signal to be received
by the tower. Position the tower so the
receiver lens (located inside the black "V"
logo) is visible from the remote control.
or +/-.
BATTERY REPLACEMENT
Your tower circulator remote includes (1) coin style CR2032 3V battery.
Battery comes pre-installed. Remove battery pull tab before first use.
Pre-installed battery has a one-year life expectancy (dependent on
use) after pull tab has been removed from remote.
1. For battery replacement, the remote requires one coin style CR2032
3V battery. Always use the correct size and grade of battery for this
product.
2. To replace battery, open battery door on the back side of the
remote control (you will need to loosen the small screw on door
using a #1 Phillips screwdriver). If necessary, clean the battery
contacts and also those of the device prior to battery installation.
Remove any plastic protection from the battery and place it
in the remote with the + side facing out. Ensure the battery is
installed correctly with regard to polarity. Replace the battery door
and screw.
Note: Remove battery from the remote control when not in use for an
extended period of time and always remove dead battery immediately
and replace with fresh. Do not store dead battery in remote.
WARNING: This product contains a button battery. If swallowed,
it could cause severe injury or death in just 2 hours. Seek medical
attention immediately.
9
English
Publicidad
