wolfcraft 5017 000 Traduccion Del Manual De Instrucciones Originale página 13

5
„ Ensure that the angle grinder is correctly aligned and place the angle grinder
with the spindle on the shaft of the dust extraction hood.
6
„ Press and hold the locking button.
„ Screw the shaft of the dust extraction hood onto the spindle of the angle
grinder and tighten it using an open-end spanner (22 mm).
„ Let go of the locking button.
„ Check that the rubber sleeve is seated correctly.
7
„ Align the mounting bracket, but do not tighten the nut yet.
„ Place the additional handle with the matching washer on the mounting bracket
and the angle grinder.
8
„ Tighten the additional handle (I).
„ Tighten the nut on the mounting bracket (II).
9
„ Loosen the wing screw and extend the base plate.
13