Publicidad
Idiomas disponibles
Idiomas disponibles
TOPCOM Feetwarmer 1000
3
Button description
1.
Power adapter Jack
2.
Heating switch
3.
Vibration intensity switch
4
Installation
4.1
Connecting to the main power.
Only use the power adapter supplied. Do not use other adapters, as this may
damage the device.
The wall outlet for the power supply must be close and accessible.
•
Plug one end of the power adaptor (12V, 1000mA) into the power adapter jack
the remote controller.
•
Plug the other end into the 100-240V mains power socket.
5
Using the massager
•
Choose a comfortable chair matching your stature.
•
For best use, place the Feet Warmer 1000 on a flat floor.
•
Put both feet into the massage slot.
•
Set the intensity switch
•
To deactivate the vibration, set the switch
•
To activate the heating, set the heating switch
•
To deactivate the heating, set the switch
Disconnect the unit immediately from the mains power after use.
Do not use the vibration or the heating for more than 15 minutes.
6
Technical data
Dimensions (W/H/D)
Weight
Power supply
–
Input:
–
Output:
7
Cleaning
40C
•
Remove the fleece lining from the feet massager by opening the zipper.
•
Machine washing of the inner lining is possible; however, hand wiping will prolong the life of the lining.
•
Place the inner lining in a net bag and seal it.
•
Use a small amount of detergent and set the washing machine to a "Delicate Wash" with a maximum temperature of 40°.
•
When washed, remove the lining from the net bag and drape it on a clothes line to dry.
Allow the blanket to dry
•
WARNING
•
The inner lining is washable, but do not attempt to machine wash outer fabric.
•
Never use abrasive cleaners, brushes, gasoline, kerosene, glass polish or paint thinner to clean.
•
Do not wring out
•
Do not dry using a tumble dryer
•
Do not iron
•
Do not dry clean.
•
Don't connect the Feet Warmer 1000 to power supply to dry it.
•
Don't dry it in the sun or iron it, which will cause safety problems because of the aging of the insulating layer.
•
Do not use an appliance such as a hair dryer to dry it
8
Storage
Store the device in its original box on a safe, dry and cool place. Avoid contact with sharp edges or pointed objects which might
cut or puncture the fabric. Do not wrap power adapter cord around the unit. Do not hang the unit by power adapter cord.
This product is in compliance with the essential requirements and other relevant
4
to
for low intensity vibration or to
3
to position '0'
3
to position 'I'.
2
to position '0'
2
300 x 340 x 210 mm
770 g
100-240 V AC / 50-60 Hz / 1.3A
DC 12 V / 1000 mA
naturally.
provisions of the directive 2004/108/EC.
The Declaration of conformity can be found on:
http://www.topcom.net/cedeclarations.asp
3
on top of
for high intensity vibration.
TOPCOM Feetwarmer 1000
1
HEALTH
I
O
2
O
Feetwarmer 1000
Publicidad
