Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Section 2. Cleaner Specifications
2.1
General Specifications
The general specifications for the cleaner are as
follows:
WARNING
Only use the battery charger supplied with the cleaner.
Battery Charger Supply
Voltage
Supply Voltage
Battery Capacity
Operating Power
Cleaner Size (WxDxH)
Weight of Cleaner
Packed Weight
Filtration
Cycle Lengths
Charge Temperature
Water Temperature
Range
Operating Depth
*Class II: An appliance with double insulation
or reinforced insulation that does not require
grounding.
Contents
The packaging should contain the following items:
• Polaris Cleaner
• Charger
Figure 1.
Contents
Page 6
110-240V AC; 50/60 Hz
Class II*
21.6V DC
5.1 Ah
25 W
14 x 11.4 x 11.4 inches
(36 x 29 x 29 cm)
13 lbs. (6 kg)
17.6 lbs. (8 kg)
All-purpose filter canister
90 min floor only
Max 109°F (43°C)
Min 40°F (5°C)
Max 95°F (35°C)
Min 55°F (13°C)
Max 13 ft. (4 m)
Min 15 in. (40 cm)
• Removal Hook
• Floating Leash
Polaris
PIXEL
®
™
Section 3. General Cleaner
Operation
CAUTION
To prevent damage to the cleaner, be sure to adhere to the following
guidelines:
• Remove the cleaner from the pool after the cleaning cycle is
completed.
• Store out of direct sunlight or inclement weather.
• For retrieval, use the manual retrieval hook or floating leash.
• Take additional care when lifting the cleaner out of the pool.
It becomes heavier when filled with water.
• Always remove the cleaner from pool when super chlorinating
or adding acid.
• Do not handle cleaner while it is in operation.
• Ensure that the cleaner is not in running mode before handling.
WARNING
DO NOT use an extension cord with the Charger
• Follow all charging instructions and do not charge outside of
the temperature range specified in the instructions. Charging
improperly or at temperatures outside of the specified range may
damage the battery and increase the risk of fire.
• When charging, cleaner must NOT be exposed to direct sunlight,
rain or inclement weather, heat ignition sources, pool and spa
chemicals or water. DO NOT position cleaner and Charger on
direct contact with soil.
IMPORTANT
• Start the cleaner, then fully submerge in the water to start
cleaning cycle.
• At the end of each cycle, remove the cleaner from the pool
and recharge.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a permanent basis.
The Polaris robotic cleaner includes a safety feature that automatically
stops the cleaner if it is powered on but not submerged in water.
Cordless Robotic Cleaner | Owner's Manual
Publicidad
