Polaris PIXEL Manual Del Propietário página 8

ENGLISH
3.4 Starting the Cleaner
1. Replace the protective cap over the charging
port.
2. Start the cleaner by sliding the power switch
down and releasing it.
Figure 3. Slide Down and Release
3. The cleaner does not begin moving until it
senses water.
Page 8
Polaris PIXEL
® ™
3.5 Submerge the Cleaner
OPTIONAL: Attach the
floating leash to the handle
to assist with removal of the
cleaner from above-ground
pools.
1. At the center point, submerge the cleaner in
the pool and hold in the vertical position to
release any air trapped inside.
1
Figure 4. Submerge the Cleaner Vertically
2. Wait for bubbles to stop completely, then let
the cleaner sink to the bottom of the pool.
2
Figure 5. Cleaner Sinking to the Bottom of the Pool
3. Cleaning cycle will start when the cleaner
detects the pool water.
WARNING
Do not enter pool while the robotic cleaner is in water.
Cordless Robotic Cleaner | Owner's Manual