Publicidad
Idiomas disponibles
Idiomas disponibles
Install_DOB30x977xx_DG68-01308A-01_EN+MES+CFR.indb 13
Install_DOB30x977xx_DG68-01308A-01_EN+MES+CFR.indb 13
4.
Lower the oven door to the fully open
position. If the oven door does not open
to a full 90°, repeat steps 1 through 3.
5.
Locate the oven door hinge locks in the
corners of the oven door, and rotate the
hinge locks toward the oven cavity to
the locked position.
See Step 1 (illustration A) in the
"Remove Oven Door(s)" section for
proper locked position.
6.
Close the oven door.
7.
When the hinges are properly installed
and the door closed, there should be
an even gap between the door and the
control panel. If one side of the oven
door is hanging lower than the other,
the hinge on that side is not properly
installed.
8.
Connect Wire Harness.
Electrical connection
For Double Ovens
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge solid copper wire.
Make sure to ground the oven.
Failure to follow these instructions can result in death, fire, or electrical shock.
This oven is manufactured with a neutral (white) power supply wire and a cabinet-
connected ground (green or bare) wire twisted together.
1.
2.
A
3.
4.
A.
UL listed or CSA approved
5.
conduit connector
6.
7.
Disconnect power.
Feed the flexible conduit from the oven
through the opening in the cabinet.
Remove junction box cover if it is
present.
Install a UL listed or CSA approved
conduit connector to the junction box.
Route the flexible conduit from the
oven to the junction box through a
UL listed or CSA approved conduit
connector.
Tighten screws on conduit connector.
See "Electrical Connection Options
Chart" to complete installation for your
type of electrical connection.
English 13
2023-02-22 오후 8:27:02
2023-02-22 오후 8:27:02
Publicidad
