Marantz professional CDR633 Guia Del Usuario página 29

3
Begin playback on input source unit.
After playback is begun on input source unit, the
CDR633 will start recording automatically when
it detects audio signal which is above the sync
level adjusted in step 2. However, after Sync1 or
Sync ALL is selected, and if the signal below the
adjusted sync level is not detected over one sec-
ond, the CDR633 will not begin recording auto-
matically even it detects the audio signal.
level
Start of recording
S_LEV
noise level
Note
In this manual, we refer to audio below the currently
specified sync level as "silence" .
When five seconds of silence occurs, the CDR633
will automatically enter record-ready mode. If you
selected "Sync 1", the sync recording setting will be
defeated.
level
S_LEV
4
To cancel sync recording, press the SYNC
REC button to select Sync OFF.
Note
• If "Sync 1" is selected, pressing the
ton will stop the disc and defeat the sync recording
setting.
• If "Sync ALL" is selected, pressing the
button will enter record-ready mode, but the sync
recording setting will be maintained.
• In either case, the sync recording setting will be
defeated if you stop by pressing the
time
REC pause
5 seconds
time
(pause) but-
(pause)
(stop) button.
29
5 – Recording—Sync recording
If the sync level setting is too high, you may lose the
first part of a song that begins softly.
level
S_LEV
This part of the track
is not recorded
Conversely, you should be aware that if the sync level
setting is too low, the noise level of an analog source
may be higher than the sync level, so that sync record-
ing fails to start.
level
Start of track is not registered
Noise is higher than
threshold
S_LEV
level
S_LEV
Song you want to record
Recording
starts
time
time
Division between tracks
Song you don't
want to record
time