Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the first 2 hours
Yearly
Yearly or before storage
Preparing for Maintenance
1.
Move the machine to a level surface.
2.
Stop the machine, remove the electric-start
key, wait for all movement to stop, and remove
the battery pack(s) from the machine before
adjusting, servicing, cleaning, or storing the
machine.
Checking and Adjusting the
Skids
Service Interval: Yearly
Check the skids to ensure that the auger does not
contact the paved surface. Adjust the skids as needed
to compensate for wear
1.
Loosen the skid bolts.
2.
Slide a 5 mm (3/16 inch) board underneath the
scraper.
Note:
Using a thinner board results in a more
aggressive scraper; using a thicker board results
in a less aggressive scraper.
3.
Lower the skids to the ground.
Note:
Ensure that the skids are flat on the
ground.
4.
Tighten the skid bolts.
Maintenance Procedure
• Inspect the auger cable and adjust it if necessary.
• Inspect the transmission cable and adjust it if necessary.
• Check for loose hardware.
• Check the skids and adjust them if necessary.
• Inspect the auger cable and adjust it if necessary.
• Inspect the transmission cable and adjust it if necessary.
• Check the air pressure in the tires and inflate them to 116 to 137 kPa (17 to 20 psi).
• Have an Authorized Service Dealer inspect and replace the traction-drive belt and/or
the auger/impeller drive belt, if necessary.
(Figure
20).
20
Figure 20
g431104
g030125
Publicidad
