Publicidad
Idiomas disponibles
Idiomas disponibles
5.4 External control
External control can be enabled via the following contacts. However, even if it's working via an external
controller, pressing
can stop the device.
Please do not apply voltage to these inputs.
Relay output
Connect terminals L & N with RA & RB cable to enable relay output. An additional on-off Relay is necessary
while bearing power is greater than 500W (2.5A).
5.5 Parameter setting
Under OFF mode, hold
Parameter
Description
1
Priming time
2
Minimum RPM
3
4
5
6
Self-priming speed
for 3 seconds to enter parameter settings.
Default setting
1 minutes
1200 rpm
PIN3
2900 rpm
PIN2
2400 rpm
PIN1
1200 rpm
2900 rpm
0~10min, by 1-minute increments
1200~2000rpm, by 100rpm increments
1200~2900rpm, by 100rpm increments
1200~2900rpm, by 100rpm increments
1200~2900rpm, by 100rpm increments
1200~2900rpm, by 100rpm increments
9
Setting range
Publicidad
