Publicidad
Idiomas disponibles
Idiomas disponibles
① When plugged in,
unlock the screen. Press
② Upon starting, pump will run at maximum speed of 2900 rpm
for one-minute self-priming. (This can be increased to 10
minutes – see Parameter settings Section 5.5)
③ Press
to choose a running speed, use
arrows to adjust by 50rpm to a specific running
speed if required.
Once the pump has finished priming, the inverter will automatically switch the pump to the pre-set speed,
indicates the pump is running and showing current rpm and power consumption.
5.3 Timer setting
To run the pump at a different times or speeds to take advantage of lower
electricity tariffs during the night, you can set up to 4 timers.
Step1: Press to
enter timer setting.
Step2: Use
or
to move cursor to the next setting. Press
decide on a specific speed if required.
Step3: Repeat the above steps to set the other 3 timers.
Step4: Hold
for 3 seconds or wait 10 seconds to save settings automatically.
A flashing
Step5: press
or
* Any overlapping of timer periods will be considered as invalid and the device will only run based on the
previous valid timer setting.
* During timer setting, if you want to abandon it, hold
Note:
*
If inactivate for 1 minute, the screen will lock automatically. Hold
*
The device has power-off memory, operation will resume upon power restoration.
* Under OFF mode, hold
lights up, hold
for 3 seconds to
to start.
to set current time. Press
to choose a speed range for timer 1, use
Press
indicates the device is waiting for start time.
to check all 4 timers to ensure there are no invalid setting.
for 3 seconds to retrieve factory setting.
or
to
move cursor to previous setting.
for 3 seconds.
for 3 seconds to unlock the device.
8
or
to
Publicidad
