Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION
–
If the red LED flashes, the battery has overheated and cannot be charged.
–
If the red and green LEDs flash together, the battery is defective.
4.
Pull the battery of the battery mount (1).
5.
Wait at least 15 min until a new charging process. Therefore, pull the mains plug out of the
outlet.
8.2
Inserting/removing the battery
CAUTION
Danger of injury!
Do not insert the battery until the battery-powered tool is ready for use.
Inserting the battery
1.
Push the battery (4) into the battery mount of the compatible power tool. The battery (4)
clicks into place audibly.
Removing the battery
1.
Press the battery (4) release button (6) and pull the battery (4) out of the battery mount of the
compatible power tool.
8.3
Check the charge status of the battery
The charge status indicator (5) indicates the charge status of the battery (4).
The charge status of the battery is indicated by the corresponding LED light lighting up.
1.
Press the charge status indicator button on the battery (7).
LED on the battery
red-orange-green
red-orange
red
8.4
Depleted batteries
• A significantly shortened operating time despite charging indicates that the battery has been
used up and needs to be replaced. Only use original replacement batteries.
• In any case, observe the applicable safety instructions as well as regulations and instructions
on environmental protection (see "Disposal and recycling").
24 | GB
Charging status
Battery full
Battery partially charged
Battery empty
www.scheppach.com
Publicidad
