Carbest 67041 Manual Del Usuario página 17

CARBEST Portable Gas Water Heater| 67041/67042
OPERATING THE APPLIANCE
• IMPORTANT- During
operation ensure that all
air inlets & exhausts are
kept free from obstruction
and closure.
• WARNING- This heater
is not to be used in wind
speeds above 10kph.
The heater will extinguish
at used in wind speed
above 10kph. This feature
is governed by the safety
feature fitted to the appli-
ance.
• Submerge the pump in a
suitable reservoir of clean
water, DO NOT use water
direct from rivers, lakes
or the ocean. Locate the
shower head in the desired
position & ensure that the
flow regulation switch is in
the "open" position.
• Turn the gas cylinder valve
on in an anti-clockwise
direction one full turn then
turn the power switch to
the "ON" position. Water
should start to flow from
the shower head within
20seconds then the elec-
tronic ignition should be
heard igniting the burner.
The burner flame can be
seen operating through the
viewing window located on
the front of the appliance.
• Taking care to measure
the temperature of the
water flowing from the
shower head, the temper-
ature can be adjusted by
turning the gas control
knob from the minimum
to maximum heat posi-
tion fo reach the most
desired heat level
• The water flow can
be stopped at any
time by sliding the
regulation switch to
the "OFF" position.
The burner will then
extinguish while the
pump will still continue
to operate.
• To reignite the burn-
er slide the flow reg-
ulation switch to the
"ON" position, water
will commence to flow
and the burner will
ignite within 5 seconds.
• If the system is off
because of overheat
temperature on
the water outlet,
the system will be
off automatically and
not be restarted until
operate manually. To
restart the system, set
the Power switch to the
"OFF" position, and
wait for the water outlet
temperature lower to
the limit of 50°C, then
switch to "ON"
again, burner will be
reignited, and hot water
will commence to flow.
• IMPORTANT:
Water remaining in the heater exchang-
er while the flow is stopped may
become hot. When the flow is resumed
the user must check the temperature out-
put to ensure that it is suitable for use
and has not become too hot.
• Once the user has finished using
the appliance switch the flow regulator
to the "OFF" position and then turn the
"Power" switch "OFF".
17
DE
EN
IT
ES
FR
NL
FI
DK
SE