Publicidad
Idiomas disponibles
Idiomas disponibles
Part 4
INSTALL THE OVEN
1
CABINET INSTALLATION
The fifth step of the installation is to install the oven into the cabinet as follows:
1. Sliding the oven into the opening.
a. Loop (do not tie) a 36" (91 cm) string around the conduit before the oven is slid into place.This will keep the
conduit from falling behind the oven.
b. Lift oven into cabinet cutout using the oven opening as a grip. Carefully push against the oven front frame.
Do not push against outside edges.
c. While sliding the oven back, pull the string so that the conduit lies on the top of the oven in a natural loop.
d. When you are sure the conduit is out of the way, slide the oven 3/4 way back into the opening. Remove the
string by pulling on one end of the loop.
CAUTION
• DO NOT block the oven air exhaust
located at the bottom of the oven.
- Blocking the exhaust may cause cabinet
damage and product malfunction.
2. Securing the oven.
a. Using the mounting holes on the oven side trim
as a guide, drill pilot holes for screws provided
(For securing the double wall oven, use a
minimum of 4 screws, one on each side in both
the upper and lower ovens. For securing the
single wall oven, use a minimum of 2 screws, one
on each side.)
b. Secure the oven to the cabinet with screws
provided.
If the cabinet is particle board, you must use 3/4"
particle board screws. These may be purchased
at any hardware store.
3. Reinstalling the oven door.
• Mounting screws must be used.
- Failure to do so can result in the oven falling
out of the cabinet causing serious injury.
- When you install the oven door, be carefull not to
bump the metal bottom trim.
- 11 -
WARNING
Mounting
Hole
Locations
Mounting
Hole
Locations
Publicidad
