Publicidad
Idiomas disponibles
Idiomas disponibles
Part 2
INSTALLATION REQUIREMENTS
4
PREPARATION FOR MOVING THE OVEN
The second step of the installation is to remove any packing material from the oven before installing the oven.
1. Remove all tape from around the oven.
2. Open the oven door and remove packaging materials and oven racks inside the oven.
3. Door removal is not a requirement for installation of the oven, but is an added convenience.
To remove the door, follow the steps below.
Step. 1
Fully open the door.
Step. 2
Pull the hinge's locks up
towards the door's
frame, to the unlocked
position.
4. Place the oven on a table or platform even with the cutout opening. (The table or platform must support 190
lbs [86 Kg] for a single built-in oven, 325 lbs [147 Kg] for a double built-in oven.)
CAUTION
• Make sure the cabinets and wall
coverings around the oven can
withstand the temperature (up to
194 °F [90 °C]) generated by the
oven.
- Discoloration, delamination or melting may occur.
IMPORTANT NOTE
• Do not lift the door by the handle. The oven door is
very heavy. Firmly grasp the door by the sides before
lifting it off the hinges.
• Do not lay the oven door on its handle. Doing so may
cause dents or scratches.
• Use two or more people to lift or move the oven
into the cabinet opening. Use caution when lifting
the oven and wear gloves to protect hands from any
sharp edges. Failure to follow these instructions may
result in injury.
Lock
Slot
Unlock
Hinge
lock
Step. 3
Firmly grasp both sides of the door at the top.
Step. 4
Close door to the door removal
position, which is
approximately 5 degrees.
Step. 5
Lift door up and out until the
hinge arm is clear of the slot.
• DO NOT remove spacers on the
side walls of the built-in oven.
- These spacers center the oven in the space
provided. The oven must be centered to prevent
excess heat buildup that may result in heat
damage or fire.
- 7 -
about 5
CAUTION
Spacer
Publicidad
