Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
An accurate maintenance guarantees good functioning and long-
lasting performance. Special care needs to be taken with the grease
filter:
to access the filter, proceed as described in the PANEL OPENING
chapter.
Remove the grease filter, using the special handle.
To refit the grease filter after cleaning, carry out the same
operation in reverse order.
To remove the carbon filter, if fitted, follow the same steps as for
the grease filter.
The carbon filter is located immediately above the grease filter.
Tepid water and neutral detergents are recommended to clean
the appliance, while abrasive products should be avoided.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person
in order to avoid a hazard.
Replacement of the LED bar:
Using an appropriate tool, remove the LED bar from its seat (refer to
Fig. 15), disconnect it electro nically throught the appropriate
conector then re place it with a LED bar with same characteristics.
Replacement of the LED bar GLASS PANEL
To remove the led bar , it is recommended to remove the steel bar as
shown in Fig. 16.
Replace the led bar with one of the same characteristics.
Refit the steel bar.
POR
E L A N T O - N A T O I N I T A L I A
48
Publicidad
