Parkside PPBSA 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 30

GB MT
Recharging the battery
Allow a hot battery to cool before
charging.
Only charge the battery (11) when
the­red­LED­on­the­charge­status­indi-
cator (12) is on.
1. Remove the battery (11) from the ap-
pliance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (11) in the charging
compartment of the battery char-
ger (23).­
3. Plug the battery charger (23) into a
mains outlet.
4. Once charging is complete, disconnect
the charger (23) from the mains supply.
5. Remove the battery (11) from the char-
ger (23).
Overview of the control display on
the charger (23):
Green LED lights up without battery
inserted: Charger ready.
Green LED lights up:
Battery such alleged charged.
Red LED lights up: Battery charging.
Red LED flashes: Battery overheated
Red + green LEDs flash:
Defective battery
Note the label on the device itself
for­the­LED­display­on­the­smart­
charger.
Inserting / removing the
device's battery pack
Inserting the battery pack:
1. Move the rotation direction switch (6)
onto its middle setting (lock).
30
2. Slide the foot of the device onto the bat-
tery pack (11) until it clicks into place.
Removing the battery pack:
1. Push the release button (13) and pull
the battery pack (11) out towards the
front of the device.
Choice of gear
Slide the gear selector (5) to 1 or 2,
corresponding to a low or high torque
selection.
1st gear .............................0-550 min
2nd gear .........................0-2200 min
A gear change may only be
performed in standstill mode!
Set the direction of
rotation
You­can­select­the­direction­of­rotation­
with the direction switch (clockwise and
anticlockwise direction) and secure the
device against accidental start up.
The arrow on the direction switch indicates
the working direction.
1. Wait for the device to shut-down.
2. Push the direction switch (6) into the
desired position:
Clockwise direction:
To drill and screw in screws. Press the
direction switch to the left with the ar-
row pointing forwards
Counter-clockwise direction:
To unscrew screws. Press the direction
switch to the right with the arrow poin-
ting backwards
3. Switch lock: Bring direction switch to
neutral position.
-1
-1