Parkside PPBSA 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 32

GB MT
Removing the auxiliary handle
1. Turn the handle (20) of the auxiliary
handle (21) in an anticlockwise direc-
tion.
2. Press the handle (20) towards the ex-
tension (19) and hold it in position.
3. Remove the auxiliary handle (21) from
the device by pulling the loop (17) on
the auxiliary handle (21) over the drill
chuck (2).
With­the­butterfly­screw­(18),­you­
can­fix­a­depth­stop­(optionally­avai-
lable, see section "Spare parts/accesso-
ries").
Switching on/off
By using the on/off switch (16) you can
progressively control the speed. The longer
you push the on-off button, the higher the
speed.
With the gear selection switch (5) you pre-
select a speed, see the section "Gear selec-
tion".­With­the­slip­clutch­selection­switch­
(4), you can choose the drilling
or screw
operating mode, see the sec-
tion­"Switching­the­slip­clutch­on/off".
We recommend running the screw opera-
ting mode in 1st gear.
1. Press the on/off switch (16) to start the
device.­The­LED­work­light­(14)­lights­
up during operation and approximately
10 seconds after you release the On/
Off switch (16).
The­lighting­duration­of­the­LED­
work light (14) can be set in the
Lidl Home App, see section "Connec-
ting the device with the Lidl Home App
>­App­functions".
2. To turn it off, release the on/off
switch (16).­When­you­move­the­direc-
tion switch (6) to the middle position,
32
the device is secured against being
switched on.
During breaks in work, the device
can be hung from a belt, using the
integral metal clip (9). Take care to
ensure that the device is switched
off and secured against accidental
activation.
The metal clip is also suitable for
opening bottles with bottle caps.
Connecting the device
with the Lidl Home App
The device can only be connected to
the Lidl Home App if you are using it
with a Smart Performance battery.
Upgrading­the­firmware­can­change­
the features of the app.
1. Slide the device base onto a Smart Per-
formance battery until it clicks into pla-
ce.­Briefly­press­the­On/Off­switch­(16).
The­smart­app­LED­
next­to­the­LED­work­light­(14)­
lights up.
2.­Enable­Bluetooth
3. Open the Lidl Home App.
From here there are options

and to connect the device.
 If­this­is­the­first­device­you­want­to­con-
nect to the app:
"At home",­select­the­op-
4. On the tab
tion "Add device".
The app scans the area for available de-
vices and indicates if available devices
have been found.
If this is not the case, read on if

possible
(15)
® on your smartphone.
 
, ,
.
