Parkside PPBSA 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 31

The direction changed may only be
performed in standstill mode.
Torque setting
You­can­preset­the­maximum­torque­by­ro-
tating the torque adjustment ring (3).
25 torque levels are provided.
1. Turn the adjusting ring (3) to select the
desired torque:
Step 1 --> lowest torque,
Step 25 --> highest torque.
2. Start with a lower torque step and in-
crease according to requirement.
Torque adjustment should only be
performed in standstill mode.
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
This sound is caused by the slip clutch.
Switching the slip clutch on/
off
The slip clutch may only be switched on/
off when at a standstill.
To use the screw operating mode, switch
the slip clutch on.
∙
Set the slip clutch selection switch (4)
so that the screw symbol
the majority of the vision panel.
To use the drill operating mode, switch the
slip clutch off.
∙
Set the slip clutch selection switch (4)
so that the drilling symbol
the majority of the vision panel.
1. Rotate the keyless chuck (2) counter-
2. Push the tool as far as possible into the
3. Rotate the chuck clockwise to clamp
4. To remove the tool again, rotate the
1. Turn the handle (20) of the auxiliary
2. Press the handle (20) towards the ex-
takes up
3. Slide the loop (17) on the auxiliary
4. Release the pressed handle (20). Make
takes up
5. Tighten the handle (20) of the auxiliary
Tool change
clockwise, until the drill chuck aper-
ture (1)­is­large­enough­to­accommo-
date the tool.
keyless chuck (2).
the­tool­firmly.
keyless chuck (2) and pull out the tool.
At the centre of the bottom rear of
the­handgrip­(7)­you­will­find­a­
magnetic bit holder (8) where you
can secure a bit you don't currently
need.
Mounting/removing the
auxiliary handle
Operate the device only with
a mounted auxiliary hand-
le (21).
Mounting the auxiliary handle
handle (21) in an anticlockwise direc-
tion.
tension (19) and hold it in position.
This extends the loop (17).
handle (21) over the drill chuck (2).
sure (by slightly rotating) that the au-
xiliary handle (21) is engaged in the
notches on the device housing.
handle (21) by turning it in a clockwise
direction.
GB MT
31