Parkside PLDM A1 Instrucciones De Utilización Y De Seguridad página 53

˜ Calibration
NOTES:
The thickness of the calibration plate
o
range of 1 .5 mm to 2 .2 mm .
The initial display is 1 .80 mm . Press the TEST button
o
to increase the reading on the display
UNIT button
The reading should equal the thickness value of the
o
calibration plate . For example, if the thickness of the
calibration plate is 1 .76 mm, press the UNIT button to
decrease the reading on the display to 1 .76 mm .
The thickness of the calibration plate should be greater than
o
the layer thickness on coated panel .
1 . Before a measurement in NFe or Fe test mode is made,
ensure that in this mode, the product has been calibrated
by using the naked substrate
Alternatively a naked substrate can be used, if it is identical
to the substrate of the object to be tested .
to decrease the reading on the display .
4 ] [
must be in the
7 ] [
. Press the
2 ] [
of the object to be tested .
8 ] [
[ 3 ]
GB/IE 53