Adjusting The Transmit Power; Using Scan; Using Step; Using Channel Mode - Uniden UM525 Manual Del Usuario

Adjusting the Transmit Power

Press HI/LO/SCRAMBLER to adjust the transmit power. If the transmit power on the currently
tuned channel is set to Hi (25W), pressing HI/LO/SCRAMBLER changes it to Lo (1W), and
appears on the display. If the transmit power on the currently tuned channel is set to Lo,
LO
pressing HI/LO/SCRAMBLER changes it to Hi, and
Important: The radio automatically sets itself to low transmit power if you tune to Channels
13, 67, 75, 76, and other low-power channels. Although you cannot change the transmit power
to high on Channel 75 or Channel 76, you can change the transmit power to high on Channel
13 or Channel 67 by holding down Hi/LO/SCRAMBLER while transmitting on those channels.
Notes:
• You cannot change the transmit power while the radio is set to Scan mode.
• The radio automatically sets itself to high transmit power if you use PUSH/SELECT to tune to
Channel 16, press 16/9 TRI, or it receives a distress call. The radio sets itself back to low
power if you use PUSH/SELECT to select another channel.

Using Scan

Note: If you hold down STEP/SCAN while the radio is set to WX mode or Coast Guard/
Distress/Hailing mode, it cancels that mode and starts memory channel scanning.
Using Triple Watch Scan
Triple Watch lets you easily scan emergency channels along with a channel you select. To use
Triple Watch scan, hold down STEP/SCAN for about 2 seconds. The radio scans Channel 16,
Channel 9, and the current memory channel.
Using Normal Scan
Normal scan lets you quickly scan and tune only those channels you select. To use normal
scan, set the radio to Triple Watch scan then hold down 16/9 TRI for about 2 seconds. The
radio scans any channels you saved to its memory and SCANNING appears.
Notes:
• If you use normal scan, the radio does not scan any emergency channels. Use Triple
Watch scan (see "Using Triple Watch Scan") to scan emergency channels.
• You must save at least one channel in the radio's memory to use normal scan. See "Saving
Channels in Memory" on Page 23 for more information.

Using Step

Step lets you quickly tune through the channels you saved in the radio's memory. To use step,
repeatedly press STEP/SCAN. The radio tunes a channel you stored in the memory each time
you press STEP/SCAN.

Using Channel Mode

Hold down MEM/UIC for about 2 seconds to change the radio mode from USA to INTERNATIONAL
to CANADIAN. ,
USA INT
Notes:
• The radio saves the current channel mode setting when you turn it off then turn it back on.
20
TRI
, or appears on the display.
CAN
appears.
HI
appears on the display.
Basic Operation