Publicidad
EX100_978030-01.qxp_Innenseiten_EX100 14.08.23 11:57 Seite 13
The spraying process is initiated by pres-
l
sing the push button (A) on the valve
body. Releasing the push button (A) im-
mediately interrupts the spraying process.
Pump up the unit again once the pressure
l
has dropped to around 1.5 bar so as to en-
sure a con sistent distribution of the
sprayed liquid.
Emptying and Service
Hold the device with the container facing
l
upwards and press the pushbutton until
the overpressure has escaped from the
container.
Unscrew the pomp carefully, at first only a
l
few turns by left-hand rotation, so that com-
pressed air being still in the tank can
escape.
Only then unscrew the pump completely
and take it out of the tank.
Empty and wash out the unit after use.
l
Note! Any remaining liquid in the tank
can be emptied out completely through
the filler opening. The type of flushing
liquid to be used and how it is to be dis-
posed of will depend on the details given
by the manufacturer of the liquid to be
sprayed. Also consider whether the tank
is resistant to the flushing liquid.
The pump will last much longer if the
l
pump O-ring (E) is lubricated from time to
time with a little re si n- and acid-free
grease.
Note! Above-average use due to manner
of operating (including the tranport to
the place of operation and the storage
when not using the sprayer), influences
of the surroundings (of the place of oper-
ation and the storage place), inadequate
maintenance and care may lead to an
early wear of the sprayer. Therefore, the
sprayer should be checked for secure and
serviceable state before use. It should at
least be checked for externally visible
damages.
Expecially when there occure damages
which endager the security, at least how-
ever after 2 years, the sprayer should spe-
cially be examined by one of the manu-
facturer's service stations.
Spare parts
728891.0000 . . . . . . . . . . . . . . . . . . Set of seals
13
GB
Publicidad
