Hypertherm Powermax45 SYNC Guia Para Empezar página 14

Getting Started Guide
Examine the torch and torch lead:
Is the torch lead twisted or kinked?

Is the O-ring on the torch head dry, cracked, or damaged?

In some conditions, restarting the plasma power supply can remove a fault condition.
Do a gas test
Do a gas test to see if sufficient gas pressure is exiting the torch. The gas test lets you see the
actual gas pressure of the plasma power supply so that you can compare it to the inlet set pressure.
CHANCE OF BURNS AND CUTS
Point the torch away from you before doing a gas test. Always keep hands, clothes, and objects clear of
the torch tip. Never point the torch toward yourself or others.
Enter gas test mode
1. Unlock the torch and then pull the torch trigger one time to get the warning puffs of air.
2. Press and hold the Mode
button for approximately
1
five seconds.
3. Release the Mode button
when the display
shows P.C.

P.C. indicates
pressure check.
The set pressure
Make note of the set pressure so that you can compare it to the actual pressure.
14
WARNING
2
flashes on the display before the actual output gas pressure
3
English Revision 0
1 2
3
811520MU Getting Started Guide
shows.
4
4
Powermax45 SYNC