Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Residual heat indicator does not
come on.
Hob²Hood does not work.
The control panel becomes hot to
the touch.
There is no sound when you
touch the panel sensor fields.
The indicator above the symbol
comes on.
The control bar blinks.
and
appear simultane‐
ously.
and
appear simultane‐
ously.
and
appear simultane‐
ously.
You hear a beep sound, the indi‐
cators above
blink and
SenseBoil® does not start.
SenseBoil® / SenseFry does not
work.
22
ENGLISH
Possible cause
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor is damaged.
You covered the control panel.
You use a very tall pot which blocks
the signal.
The cookware is too large or you put
it too close to the control panel.
The sounds are deactivated.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the zone or
the zone is not fully covered.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
The power is too low due to unsuita‐
ble cookware or an empty pot.
The pot is empty or contains some
liquid other than water, e.g. oil.
There is too much or too little water
in the pot.
You boiled some food other than wa‐
ter and potatoes. The boiling point
was moved in time and SenseBoil®
could not work properly.
None of the cooking zones is ready
to be used with SenseBoil®. There
is some residual heat on the cooking
zones you want to choose or they
are still in use.
The power level of the hob is too
low.
Remedy
If the zone operated sufficiently long to
be hot, speak to an Authorised Service
Centre.
Remove the object from the control
panel.
Use a smaller pot, change the cooking
zone or operate the hood manually.
Put large cookware on the rear zones,
if possible.
Activate the sounds. Refer to "Daily
use".
Refer to "Child Safety Device" and
"Lock".
Put cookware on the zone so that it
fully covers the cooking zone.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Use the appropriate type of cookware.
Refer to "Hints and Tips" and "Techni‐
cal Data".
Do not activate any zone with an emp‐
ty pot on it.
Avoid using the function with liquids
other than water.
Only boil water and potatoes with the
use of SenseBoil®. Refer to "Hints and
Tips".
Finish your previous cooking activities
and choose a free cooking zone with‐
out any residual heat.
Set the power level to a higher value.
Make sure that the selected power fits
the house installation fuses. Refer to
"Before first use" > " Power limitation".
Publicidad
