Emerson ControlWave Micro Instrucciones Para Un Uso Seguro página 6

Safe Use Instructions – ControlWave Micro
Part D301761X012
January 2024
Process Automation Controller Instruction Manual
(part D301392X012) for specific instructions on
configuring the PSSM to your site's requirements.
6. Install and configure the CPU and communications
and I/O modules. Refer to the
Process Automation Controller Instruction Manual
(Part D301392X012) for specific instructions on
configuring these modules to your site's
requirements.
7. Connect the ControlWave Micro to power, I/O
devices, and communication devices. The external
connections (or field terminals) are all located on the
termination board. The terminal block accepts wires
up to 1.63 mm (14 AWG) in size.
The ControlWave Micro connectors use compression
terminals. The input power termination (IN+ / IN–)
uses a removable connector and accommodates
wiring up to 1.63 mm (14 AWG) in size. In all cases,
make connections by baring the end (6 mm
maximum) of the wire, inserting the bared end into
the clamp beneath the termination screw, and then
tightening the screw to 0.25 N-m.
The inserted wires should have a minimum of bare
wire exposed to prevent short circuits. Allow some
slack when making connections to prevent strain.
Notes:
 Caution: Do not over-torque the connector
screws.
 Check the input power polarity before you turn on
the power.
8. Apply power to the ControlWave Micro.
4
ControlWave Micro
9. To place the ControlWave Micro in service, use
ControlWave Designer software to create a
ControlWave project that meets the needs of your
particular application. Download the project into the
unit. Then use the Flash Configuration utility to set
configuration parameters.
Note: For an overview of this process and references
to other relevant documentation, see the
ControlWave Micro Quick Setup Guide
(D301425X012).
10. If you are experiencing problems that appear to be
hardware-related, verify the wiring. If you still
experience problems, contact your local sales office
for return authorization.
11. To remove the ControlWave Micro from service:
Verify safe area.

Disconnect power from the unit.

Remove all external wiring connections.

Remove the ControlWave Micro from its

enclosure.
12. Place the ControlWave Micro in a suitable container
for transportation or shipment.
www.Emerson.com/SCADAforEnergy