Mx Onda MX-PIP2200 Manual De Instrucciones página 20

Fan
At the base of the plate there is a fan whose objective is to maintain a stable
temperature inside the induction plate.
Every time the board is turned on and the power or temperature is adjusted, the fan
will also start. When the board is turned off, the fan will remain running and will
automatically turn off after 1 minute.
On the base of the hob you should NEVER place kitchen towels, cloths or other
objects that could obstruct the fan holes, as this would prevent adequate
ventilation and cause overheating of the circuits, causing the safety protections to
operate.
Note:
Remember that the fan will remain running for 1 minute after turning off the board.
This is normal and does not indicate a malfunction.
INSTALATTION
1. Place the plate on a stable and level surface, away from hot places, high
humidity or near flammable materials (oil, curtains, rags, etc.).
2. To ensure adequate ventilation, leave at least 30 cm of separation on each
side of the plate. DO NOT block the ventilation slots on both sides and back of
the board as well as the fan holes (located on the base of the board).
3. Completely unroll the power cable and plug the appliance plug into the mains.
The buzzer will emit a "beep" to let you know that the hob has been plugged
into the mains socket. The display and all indicator lights on the control panel
will illuminate briefly. The button 1 indicator ( ) will flash.
20