Publicidad
Idiomas disponibles
Idiomas disponibles
Chapter 2
Operating Instructions
2.1
Charging Procedure
You can charge a stand-alone battery or a battery attached to a radio. Charge the batteries at room
temperature for optimal charging performance.
Procedure:
1. Place the charger on a flat surface.
2. Connect the USB-A plug end of the charging cable to the power adapter.
3. Firmly insert the USB-C plug end of the charging cable into the USB-C inlet socket at the back of the
charger.
4. Plug the power adapter into a matching power outlet.
The LED indicator illuminates red for one second on successful power-up. Check the power supply
cord connection if the LED indicator fails to illuminate.
5. Insert a radio or a stand-alone battery into the charging pocket.
6. When your radio or the stand-alone battery is properly placed in the charging pocket, the LED
illuminates steady red indicating charging is in progress.
Result: The LED indicator illuminates steady green on charging completion.
NOTE:
●
Battery charging is stopped immediately upon charging completion. If a fully charged battery is
placed into the charger, the charger will charge the battery for 10 seconds and stop charging.
●
The time taken to fully charge a stand-alone battery and a battery attached to the radio is the same
provided that the radio is turned off during charging.
2.2
Charger LED Indication
The following table describes the LED indications when the charger is in use.
Table 4: Charging Indication
LED Indication
LED illuminates red for one sec-
ond and turns off
LED off
Charger Status
Power is connected.
No battery is inserted.
MN010372A01-AA
Chapter 2: Operating Instructions
11
Publicidad
