EINHELL GP-CT 36/35 Li BL Manual De Instrucciones Original página 24

7. Cleaning, maintenance and
ordering of spare parts
Danger!
Before putting away or cleaning the grass trimmer,
switch off and remove the battery pack.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend that you clean the equipment
immediately after you use it.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use cleaning
agents or solvents; these may be aggressive
to the plastic parts in the equipment. Ensure
that no water can get into the interior of the
equipment. The ingress of water into an elec-
tric tool increases the risk of an electric shock.
•
Use a brush to remove deposits from the sa-
fety guard.
7.2 Replacing the line spool
Danger! Remove the battery packs!
1. Fig. 19 Press the line spool housing together
at the points marked M and remove the spool
cover.
2. Remove the empty string holder.
3. Fig. 20 Thread the end of the line on the new
line spool through the eyelet (F) in the spool
cover and allow approx. 18 cm of line to pro-
ject.
4. Press the spool cover back into the line spool
housing.
7.3 Replacing the cutting line
Danger! Remove the battery packs!
1. Fig. 19 Press the line spool housing together
at the points marked M and remove the spool
cover.
2. Remove the empty string holder.
3. Remove any remaining cutting line if there is
any.
4. Fig. 21 Insert the new string into the string hol-
der (D) inside the spool.
5. While keeping the string under tension, wind it
up in the direction indicated by the arrow.
6. Fig. 22 Hook the line, approx. 20 cm before
the end of the line, into one of the line holders
on the edge of the spool.
Anl_GP_CT_36_35_Li_BL_SPK13.indb 24 Anl_GP_CT_36_35_Li_BL_SPK13.indb 24
GB
7. Fig. 20 Thread the end of the line on the new
line spool through the eyelet (F) in the spool
cover.
8. Pull the line sharply to release it from the line
holder.
9. Press the spool cover back into the line spool
housing.
When you start the equipment again the line will
be cut to the perfect length automatically.
Caution! Bits of the nylon line could cause
injury when fl ung out.
7.4 Maintenance
There are no other parts inside the equipment
which require maintenance.
7.5 Ordering spare parts
Please provide the following information on all
orders for spare parts:
•
Model/type of the equipment
•
Article number of the equipment
•
ID number of the equipment
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
Spare line spool Art. No.: 34.050.96
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Defective components must be dispo-
sed of as special waste. Ask your dealer or your
local council.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30 °C.
Store the electric tool in its original packaging.
- 24 -
02.05.2023 09:49:53 02.05.2023 09:49:53