Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator
installed in place, you are ready to set up and enjoy the features and
functions
of the appliance.
By completing
the following steps, your Refrigerator
should be fully operational.
1. Place the Refrigerator
in an appropriate
location with reasonable
clearance
between
it and the wall.
Refer to installation
instructions
in this manual.
2. Once the Refrigerator
is plugged
in, make sure the interior light comes on when you open the doors.
3. Set the Temperature
control to the coldest temperature
and wait for an hour. The Freezer will get sligh
chilled and the motor will run smoothly.
4. After powering
the Refrigerator,
it will take a few hours to reach the appropriate
temperature.
You can
store food and drinks in the Refrigerator
after the temperature
is sufficiently
cool.
Check the accessories
listed below.
Water filter
Hex wrench
Fastener
Compression fitting
@
Compression nut
Clip fitting lock(red)
Required
Tools (Not provided)
Philips screwdriver(+)
Flat-blade screwdriver(-)
Socket wrench (7/16")
Pliers
Allen wrench(3/16")
REMOVING THE REFRIGERATOR
DOORS
Some installations
require door removal to transport
the Refrigerator
to its final location.
Do not remove the door/drawer
if it is not needed.
Before removing the door/drawer,
make sure you read
following
items.
WARNING
®
Disconnect power to the Refrigerator before removing the door or drawer.
O
O
®
Be careful not to drop, damage
or scratch the door/drawer
while removing them.
Be careful not to get injured while removing the door/drawer.
Reattach the door/drawer
properly to avoid:
- Moisture
from air leakage.
- Uneven door alignment.
- Wasting energy due to improper
door seal.
Disassemble
the Refrigerator
doors
/_
Be careful not to drop and scratch the doors while
the
removing
WARNING
doors.
Disassemble
the Refrigerator
doors
1. With the door opened,
remove the cap top table ( 1 ) with
a flat-blade
screwdriver(-),
and close the door.
Remove the 3 screws holding down the top table ( 2 ) and
remove it.
Settng up
Publicidad
