Publicidad
Idiomas disponibles
Idiomas disponibles
ott
up your ron
Door Aofr r tor
CHECKING THE WATER DISPENSER LINE
A water dispenser
is one of the helpful features on your new Refrigerator.
To help promote
better health,
the water filter removes
unwanted
particles from your water. However, it does not sterilize or destroy
microorganisms.
You may need to purchase
a water purifying system to do that.
In order for the ice maker to operate properly, a water pressure of 20-125
psi is required.
Under normal conditions,
a 170 cc (5.75 oz.) cup can be filled in 10 seconds.
If the Refrigerator
is installed in an area with low water pressure (below 20psi), you can install a booster
pump to
compensate
for the low pressure.
Make sure the water storage tank inside the Refrigerator
is properly filled. To do this, press the water dispenser
lever until the water runs from the water outlet.
Water line installation
kits are available at extra cost from your dealer. We recommend
using a water lin
installation
kit that contains
copper
tubing and 1A" compression
nut.
Connecting
to the water supply
line
1. First, shut off the main water supply.
2. Locate the nearest cold water drinking
line and install
the pipe clamp and shut off valve.
Cold water line
Pipe clamp
Shut off valve
3. Connect
the water line installation
kit to shut off valve.
Cold water line
Pipe clamp
Shut off valve
Water line installation kit
®
After connecting
the water supply to the water filter, turn your main water supply back on and flush 4 o
more gallons into a bucket to clear and prime the water filter.
If water drop or leakage is found on the connection
area, turn off the main water supply. Check it and,
necessary, tighten it more.
18 Setting up
Publicidad
