Makita DRT52 Manual De Instrucciones página 16

Straight guide
The straight guide is effectively used for straight cuts
when chamfering.
► Fig.34
1.
Attach the guide plate to the straight guide with
the bolt and the wing nut.
► Fig.35: 1. Bolt 2. Guide plate 3. Straight guide
4. Wing nut
2. Remove the trimmer shoe from the tilt base.
Loosen the wing bolts, secure the base horizontally, and
then attach the straight guide with the clamping screw.
► Fig.36: 1. Clamping screw 2. Straight guide 3. Wing
nut 4. Base 5. Wing bolt
3. Loosen the wing nut on the straight guide and
adjust the distance between the trimmer bit and the
straight guide. At the desired distance, tighten the wing
nut securely.
4.
When cutting, move the tool with the straight guide
flush with the side of the workpiece.
Trimmer guide
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
► Fig.37
1.
Remove the trimmer shoe from the tilt base.
Loosen the wing bolts and secure the base horizontally.
2. Install the trimmer guide and guide holder on the
base with the clamping screw (A).
3. Loosen the clamping screw (B) and adjust the
distance between the trimmer bit and the trimmer guide
by turning the adjusting screw (1 mm per turn). At the
desired distance, tighten the clamping screw (B) to
secure the trimmer guide in place.
► Fig.38: 1. Adjusting screw 2. Guide holder
3. Trimmer guide 4. Wing bolt
4. When cutting, move the tool with the guide roller
riding the side of the workpiece.
► Fig.39: 1. Workpiece 2. Trimmer bit 3. Guide roller
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
TRIMMER BITS
Optional accessory
Straight bit
► Fig.40
U-grooving bit
► Fig.41
V-grooving bit
► Fig.42
Drill point flush trimming bit
► Fig.43
Drill point double flush trimming bit
► Fig.44
Corner rounding bit
► Fig.45
Chamfering bit
► Fig.46
Cove beading bit
► Fig.47
Ball bearing flush trimming bit
► Fig.48
Ball bearing beading bit
► Fig.49
Ball bearing corner rounding bit
► Fig.50
Ball bearing chamfering bit
► Fig.51
Ball bearing cove beading bit
► Fig.52
Ball bearing roman ogee bit
► Fig.53
16 ENGLISH