Automatic Programs; Music Control; Master / Slave Mode - IMG STAGELINE PARL-12 RGBW Manual De Instrucciones

7.2 Automatic programs

Two programs are available:
AUTO 1 = colour sequence with crossfading
AUTO 2 = colour sequence without crossfading
1) On the remote control, press the appropriate
button (AUTO 1 or AUTO 2) to switch on the
program desired .
Alternatively, on the menu of the spot-
light, call up the menu item
the button ENTER to confirm your selection
( or ) .
2) On the remote control, press the button
SPEED and then use the buttons UP and
DOWN to set the speed .
Alternatively, set the speed by means of
the menu: Use the buttons UP and DOWN
( ... ) to set the speed, and then
press ENTER to save the setting .
3) To activate or deactivate the stroboscope
function for the program selected and to set
the stroboscope frequency: On the remote
control, press the button STROBE to acti-
vate or deactivate the stroboscope function,
and then use the buttons UP and DOWN to
change the flash frequency .
Alternatively, set the flash frequency
by means of the menu: Go to the submenu
item , then use the button UP or DOWN
to set the flash frequency between
(permanent light) and
and finally press the button ENTER to save
the setting .

7.3 Music control

If the spotlight is to be music-controlled by
means of its microphone (6), select one of the
following two music modes:
SOUND 1 = sound-controlled stroboscopic sal-
vos with changing colours
SOUND 2 = sound-controlled colour changes
1) On the remote control, press the appropriate
button (SOUND 1 or SOUND 2) to switch on
the program desired .
Alternatively, on the menu of the spot-
light, call up the menu item
press ENTER to confirm your selection (
or ) .
2) On the remote control, use the buttons UP
and press

7.4 Master / slave mode

Multiple spotlights PARL-12RGBW can be oper-
ated in sync . In this mode, the first unit (master
unit) controls the other units (slave units) .
1) Connect the units with each other in a chain;
2) Set the master unit to one of the following
3) Set the other units to the slave mode . To
(approx . 10 Hz)
, and then
and DOWN to set the sensitivity for the mi-
crophone .
Alternatively, set the sensitivity on the
menu: Call up the submenu item
the buttons UP or DOWN to set the sensitivity
between and
ENTER to save the setting .
please refer to chapter 8 .1, skipping step 1 .
modes: automatic mode, music control or
colour spotlight mode (
do so, either press the button SLAVE on the
remote control or switch on the slave mode
by means of the menu: Select the menu item
and press the button ENTER twice .
will appear on the display .
, use
, and then press
☞
chapters 7 .1 – 7 .3) .
17