CEMO DT-Mobil Easy 125I Manual Del Usuario página 35

4. Initial setup
1. Permanently affix the stickers enclosed with
the tank documents to the front or rear panels
or to both sides (for 460 and 600 l).
8 cm
DT-Mobil Easy 460l / 600l both sides
Hazard label with UN 1202
A
(flame on red background)
Harmful to the environment
B
(dead tree/dead fish symbol)
A
B
DT-Mobil Easy 125 l rear
A
B
DT-Mobil Easy 200l front
A
B
DT-Mobil Easy 430l front
A
B
2. Unscrew the cap on the filling opening and
check the inside of the tank for contamina-
tion (clean if necessary, e.g. with a vacuum
cleaner).
3. Fill the tank (see 5.4, item 2)
i
Important:
To do this, always use an automatic de-
livery nozzle to prevent overflowing.
4. Perform a test filling as described in Section
5.5, but hold the delivery nozzle in the still-
open filling opening.
5. Close the filling opening tightly again with the
cap.
►The filling station is now ready for operation.
i
Note:
For the battery version, protect the bat-
tery from moisture.
5. Operation
5.1 Storage
During transport and storage, do not expose the
DT-Mobil Easy to direct sunlight for an extended
period of time. Excessive heating can lead to
deformation of the high-quality plastic tank and a
reduction in the quality of the fuel.
Suitable storage conditions:
• Ambient temperatures from -10 °C to +40 °C.
• Level surface.
• Cover for outdoor storage.
• Stackability:
►Max. 2 empty (!) tanks one above the other
i
Important:
When stacking:
• For the version with lid, the lid must be closed.
• To fasten, the four fixing pins on the top of the
tank must engage in the four recesses on the
underside of the tank.
GB
35