Publicidad
Idiomas disponibles
Idiomas disponibles
EN
36
Dehumidify (DRY) mode
In dehumidify (DRY) mode, the temperature cannot be adjusted, the ventilation
will fix at low speed. When the unit is operating in Dehumidify ( DRY) mode,
humidity extracted from the air is collected in an internal tank. If the tank reaches
full, the compressor and motor cut out automatically. At the same time, the
"Water Full" indicator comes on. An alarm will also sound. When the tank is full,
drain the water as shown in the page concerning "DRAINAGE". You may also
use the unit without having to empty the tank so often by using "continuous
drainage", please also refer to the page about "DRAINAGE".
Self-diagnosis
This machine is equipped with self-diagnosis function. If something is wrong in
the machine, the display window will show the sign: E1, E2, E3 or E5 , which reflects
different condition. At this time, please call your service centre.
Notes
•
To prolong the compressor's life, after switch-off of the unit, please wait for
3 minutes (at least) before re-switch.
•
The cooling system will switch off if the ambient temperature is lower than
the set one. The ventilation, however, keeps working on the set level. If the
ambient temperature rises above the selected level, the cooling will return to
work.
•
On the contrary, the heating will switch off if the ambient temperature is
higher than the set one (still, the ventilation keeps working on the set level).
As the ambient temperature drops below the selected level, the heating will
return to work.
•
This machine is equipped with ANTI-FROST function. While using the heating
function during low temperature, sometimes the heating will stop for a while
in order to melt the frost. As this occurs, just wait for the heating returns to
work.
All the above functions can also be performed with the
supplied remote control.
This remote control requires battery CR2032 x 1pc to
operate.
Publicidad
