Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Technical data ........................................................................................................EN-3
1.1 INTRODUCTION ............................................................................................EN-5
1.1.a Purpose of the manual .......................................................................... EN-5
1.1.b Consulting the manual .......................................................................... EN-5
1.1.c Key to symbols used in the manual ...................................................... EN-5
1.1.d Conventional terminology ..................................................................... EN-5
1.2 GENERAL WARNINGS .................................................................................EN-5
1.2.a Personnel qualifications ........................................................................ EN-5
1.2.b Operator position ..................................................................................EN-5
1.2.c Protective clothing .................................................................................EN-6
1.2.d General warnings before use ................................................................ EN-6
1.2.e General warnings while using the machine .......................................... EN-6
1.2.f General warnings about the batteries ................................................... EN-6
1.2.g General warnings during maintenance ................................................. EN-6
1.2.h General warnings in the event of a fire ................................................ EN-6
1.2.i Prolonged machine standstill ................................................................ EN-6
1.3 INTENDED MACHINE USE ........................................................................... EN-7
1.4 NON-INTENDED MACHINE USE .................................................................. EN-7
1.4.a Zone with risk of explosion .................................................................... EN-7
1.5 DEMOLISHING THE MACHINE .................................................................... EN-7
1.6 REFERENCE STANDARDS .......................................................................... EN-7
2.1 UNPACKING ..................................................................................................EN-8
2.1.a Standard machine equipment ............................................................... EN-8
3.1 ASSEMBLING THE COMPONENTS ............................................................. EN-9
3.1.a Positioning of the handle....................................................................... EN-9
3.1.b Assembling the tank cover .................................................................... EN-9
3.1.c Installing and connecting the batteries................................................ EN-10
4.1 CHARGING THE BATTERY ........................................................................ EN-11
4.1.a Charging the battery using the on board battery charger (if present) EN-11
4.1.b Charging the battery using an external battery charger ..................... EN-12
5.1 GETTING TO KNOW THE MACHINE ......................................................... EN-13
6.1 CONTROL PANEL .......................................................................................EN-14
7.1 FILLING THE TANK .....................................................................................EN-16
8.1 OPERATION ................................................................................................EN-17
8.1.a Checks before use ..............................................................................EN-17
8.1.b Preparing the machine and choosing the cycle .................................. EN-18
8.1.c Using the machine .............................................................................. EN-19
8.1.d End of use and switching off ............................................................... EN-19
8.1.e Maximum recovery tank water level alarm .......................................... EN-20
8.1.f Probe height ........................................................................................EN-20
8.1.g Alarms list (only for models with integrated drive mechanisms) ........ EN-21
9.1 DRAINING THE RECOVERY WATER ........................................................ EN-23
10.1 MAINTENANCE AND CLEANING .............................................................. EN-24
10.1.a Emptying and cleaning the clean water tank ..................................... EN-24
10.1.b Cleaning the recovery water tank ...................................................... EN-25
10.1.c Cleaning the squeegee .................................................................... EN-26
10.1.d Cleaning the clean water filter ........................................................... EN-26
10.1.e Replacing the brush ........................................................................... EN-27
10.1.f Replacing the squeegee rubber blades ............................................. EN-28
10.1.g Replacing the fuses ........................................................................... EN-29
10.1.h Battery charger and digital instrument configuration ......................... EN-30
TROUBLESHOOTING .........................................................................................EN-32
WIRING DIAGRAMS ............................................................................................EN-34
Contents
EN-2
Publicidad
