Husqvarna CA230 Manual De Usuario página 248

Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To replace the blades
WARNING:
before you work on any part of the
attachment. It can continue to move even
after the throttle/power trigger is released.
If you have a gasoline operated product,
disconnect the HT leads from the spark
plug. If you have a battery operated product,
remove the battery. Ensure the attachment
has stopped completely before you start to
work on it.
1. Loosen the split pin.
2. Remove the cutter package from the gear housing's
output axle.
3. Mount the cutter package onto the gear housing's
output shaft. Make sure the direction of rotation
agrees with the cutters and on the gear. The arrows
must point in the same direction.
248
Maintenance
Always stop the product
To perform daily maintenance on the
product
1. Check that the guard is undamaged and not
cracked. Replace the guard if it has been exposed
to impact or is cracked.
2. Check that the blades do not move when the throttle/
power trigger is released.
3. Check that the blades are undamaged and show
no signs of cracking or other damage. Replace the
blades if necessary.
4. Check that nuts and screws are tight.
5. Clean the outside of the product.
6. Check that the split pins and cotter pins are
undamagad and secured correctly.
742 - 004 - 16.11.2022