Publicidad
Idiomas disponibles
Idiomas disponibles
•
Make sure the cutter guard is fitted and not
damaged.
•
Check that the tines and tine guard are secured
correctly. Make sure the direction of rotation agrees
with the cutters and on the gear. The arrows must
point in the same direction.
To start the product with a cold engine
If you have a gasoline operated product, obey these
instructions to start the product with a cold engine.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To replace the blades
WARNING:
before you work on any part of the
attachment. It can continue to move even
after the throttle/power trigger is released.
If you have a gasoline operated product,
disconnect the HT leads from the spark
plug. If you have a battery operated product,
remove the battery. Ensure the attachment
has stopped completely before you start to
work on it.
742 - 004 - 16.11.2022
Operation
Maintenance
Always stop the product
•
Check that the blades do not move when the throttle/
power trigger is released.
•
Make sure the handle and safety features are in
order. Never use a product that has any parts
missing or has been modified in relation to the
specification.
•
Only use the product for the purpose it was intended
for.
•
Make sure the cutting attachment has stopped
before cleaning, carrying out repairs or an
inspection. If you have a gasoline operated product,
disconnect the HT leads from the spark plug. If you
have a battery operated product, remove the battery.
•
Wear heavy-duty gloves when repairing the
cultivator.
•
Use only original spare parts for repairs.
•
Store the product out of reach of children.
1. Run the basic product warm and then shut down the
product.
2. Mount the accessory as per the assembly
instructions.
1. Loosen the split pin.
7
Publicidad
