Publicidad
Idiomas disponibles
Idiomas disponibles
4. INTENDED USE
This tool is intended for finishing and trimming (interior
and exterior), such as door & window casing, door
jambs, baseboard, crown molding, cabinetry, cap and
shoe molding, molding, staircases, door & window
trimming, chair rail, brickmolding, hardwood flooring,
paneling, furniture, etc.
5. OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING: Keep the tool pointed away from
yourself and others when loading nails. Always
remove the nails and battery pack when tool is not in
use. Failure to do so could result in possible serious
personal injury.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
10
Installing/removing the battery
pack
Charging the battery pack
ASSEMBLY
Installing the belt hook
NOTE: The belt hook can be
installed on the left or right side
of the nail gun.
Loading the tool with 16ga finish
nails.
1. Remove the battery pack if
installed.
2. Pull the MAGAZINE RELEASE
BUTTON down and place finish
nails in the upper left corner of
channel.
3. Press the magazine release
button and allow the pusher
to push the nails up into the
channel. The pusher will rest
against the end of the nail strip.
WARNING: Use safety
gloves. Keep the tool
pointed away from yourself and
others when loading nails.
Failure to do so could result in
possible serious personal injury.
20V Cordless 16 Gauge Finish Nailer
OPERATION
Selecting the nailing mode
Single sequential actuation
mode: Provides accurate nail
placement .
Contact actuation mode: Allows
for fast repetitive nail placement
if the selector is not securely
seated in either position. Always
assure the selector is seated
properly to avoid an unexpected
nail discharge and possible
serious personal injury.
Using the on/off trigger in two
different modes
Single sequential actuation
mode:
-Push the workpiece contact
against the work surface first
and then squeeze the on/off
trigger.
-Relase the on/off trigger and
FIGURE
the workpiece contact.
Contact actuation mode:
-Squeeze and hold the trigger.
See Fig. A1, A2
Push the tool against the
work surface to depress the
See Fig. A3
workpiece contact and drive a
nail.
-Release the workpiece contact
once after each nailing action.
-Move the tool and then push the
See Fig. B
workpiece contact again.
NOTE: The nail gun will operate
only when squeezing the on/
off trigger and pushing the work
piece contact against the work
surface simultaneoulsly.
NOTE: If there is no nailing
action within 5 seconds after
pressing the on/off trigger or
pushing the workpiece contact,
release the on/off trigger or the
workpiece contact once and
See Fig. C1, C2
then operate again.
WARNING: Never wedge or
hold back the workpiece contact
mechanism during operation of
the tool. Doing so could result in
possible serious injury.
.
WARNING: The nail gun
will not function properly
See Fig. D
See Fig. E1, E2
EN
Publicidad
