HT Instruments HT4011 Manual De Instrucciones página 37

5.6. CAPACITANCE MEASUREMENT
Before carrying out capacitance measurements on circuits or capacitors, cut
off power supply from the circuit being tested and let all capacitance in it be
discharged.
Fig. 8: Use of the clamp for capacitance measurement
1. Select the CAP position.
2. Insert the red cable into input terminal V
terminal COM.
3. Position the test leads in the desired points of the circuit to be measured (see Fig. 8).
The value of capacitance is shown at display
4. If the symbol "O.L" is displayed, this indicates overload status.
5. To use the HOLD and REL functions, please refer to § 4.2
CAUTION
CAPHz% and the black cable into input
EN – 13
HT4011