Hayward AquaRite AQR-PRO-75LSE Manual Del Usuario página 22

Salt Level
Use the chart on page 6 to determine how much salt in kgs need to be added to reach the recommended levels. Use the
equations below if pool size is unknown.
The ideal salt level is between 1.2 - 2.5 g/L with 1.5 g/L being optimal. If the level is low, determine the number of M³ in
the pool and add salt according to the chart on page 6. A low salt level will reduce the efficiency of the AquaRite Pro LS
and result in low chlorine production. A high salt level can cause the AquaRite Pro LS to shutdown and may begin to give
a salty taste to your pool. The salt in your pool/spa is constantly recycled and the loss of salt throughout the swimming
season should be small. This loss is due primarily to the addition of water because of splashing, backwashing, or draining
(because of rain). Salt is not lost due to evaporation.
Type of Salt to Use
It is important to use only sodium chloride (NaCl) salt that is greater than 99% pure (EN 16401). Use only salt for
electronic chlorine generator usually available in 25 kg bags. Do not use rock salt, salt with yellow prussiate of soda, salt
with anti-caking additives, or iodized salt.
How to Add or Remove Salt
For new plaster pools, wait 10-14 days before adding salt to allow the plaster to cure. Turn the circulating pump on and
add salt directly into the pool. Brush the salt around to speed up the dissolving process. Do not allow salt to pile up on the
bottom of the pool. Run the filter pump for 24 hours with the suction coming from the main drain (use pool vac if there is
no main drain) to allow the salt to evenly disperse throughout the pool. The salt display may take 24 hours to respond to
the change in salt concentration.
The only way to lower the salt concentration is to partially drain the pool and refill with fresh water.
Always check stabilizer (cyanuric acid), when checking salt. These levels will most likely decline together. Use the
chart on page 6 to determine how much stabilizer must be added to raise the level to 25 ppm. Use stabilizer only if
necessary.
Page 5 of 16
Si = pH + Ti + Ci + Ai - 12.1
°C °F
12 53
16 60
19 66
24 76
29 84
34 94
39 100
How to use: Measure pool pH, temperature, calcium hardness, and
total alkalinity. Use the chart above to determine Ti, Ci and Ai into the
above equation. If Si equals 0.2 or more, scaling and staining may
occur. If Si equals -0.2 or less corrosion or irritation may occur.
CORROSIVE
Rectangular
Round
Oval
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
AquaRite
Calcium Total
Ti Ci
Hardness Alkalinity
0.3 75 1.5 75
100 1.6 100
0.4
125 1.7 125
0.5 150 1.8 150
200 1.9 200
0.6
250 2.0 250
0.7 300 2.1 300
400 2.2 400
0.8
600 2.4 600
0.9 800 2.5 800
- 0.2 0 0.2
SCALING
OK
M³
(pool size in meters)
Length x Width x
Average Depth
Diameter x Diameter x
Average Depth x 0.785
Length x Width x
Average Depth x 0.893
Pro LS
®
Ai
1.9
2.0
2.1
2.2
2.3
2.4
2.5
2.6
2.8
2.9
Rev. D