Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue
off and remove plug from power supply. Empty the collection tank, clean and dry the inside and
outside before storage.
REMEMBER!
must be installed before dry vacuuming again.
1
6
This Wet/Dry Vacuum has blowing capabilities. To use the blower feature follow the instructions
listed below.
WARNING:
(OR IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
CAUTION:
WARNING:
BE INHALED.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from
the hose and collection tank.
3. Remove hose from the vacuum port.
4. Insert the locking end of the hose into the blower port on the side of the powerhead and lock
into place (Fig. 2).
5. Choose the desired accessory and insert onto the free end of the hose (Fig. 3).
6. Verify that the on/off switch is in the 'O' OFF position before plugging the power cord into the
power outlet. Plug the power cord into the outlet (Fig. 4 & 5).
power cord from the outlet.
BLOWER OPERATION
2
3
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT
4
13
5
Publicidad
