Publicidad
Idiomas disponibles
Idiomas disponibles
Read this manual in its entirety, paying particular attention to the instructions for
safe use.
Carefully remove all possible fastening materials from parts, including internal
parts.
Fully remove any stickers from the surface of the appliance.
Assembly in floor-standing configuration:
1. Place the base on a flat and stable surface, check that its location complies
with the safety requirements in section 2 above. Therefore, it must be
positioned at a safe distance from fixed or moving objects, build-ups or
sources of water or other liquids, etc.
2. Insert the part of the floor-standing pedestal with a wider diameter into the
hole in the base and screw it in, turning it clockwise, keeping it as upright as
possible until it is fully tightened, that is, until further tightening is met with
considerable resistance.
3. Extract the tap screw located at the rear and bottom of the motor body,
turning it slightly counter-clockwise, until it no longer obstructs the insertion
of the pedestal in the bottom hole. If the screw starts to come out of its seat,
it can be re-inserted by resting it in the threaded hole and turning it slightly
clockwise.
4. Fully insert the motor body onto the top of the pedestal, then secure the
motor body by turning the tap screw clockwise until rotation is met with
considerable resistance.
5. For greater safety, lift the entire appliance by a few centimetres and check
that none of the parts disconnect from the others. The appliance can now be
put into operation.
Assembly in floor-based configuration:
1. Place the base on a flat and stable surface, check that its location complies
with the safety requirements in section 2 above. Therefore, it must be
positioned at a safe distance from fixed or moving objects, build-ups or
sources of water or other liquids, etc.
2. Insert the part of the coupling shaft with a wider diameter into the hole in the
base and screw it in, turning it clockwise, keeping it as upright as possible until
Remove the film on the bottom part of the remote control
battery compartment, pulling it outwards.
20
Publicidad
