Hisense RW3N230GELF Manual De Operación página 61

Display controls
•Each valid button press emits a
short sound.
•The corresponding temperature
setting is reflected in the display,
and the setting takes effect and is
stored after 10 seconds of operation
without touch the key.
Standby Mode
When you do not plan to use this
appliance for a period of time, you
can save energy by entering the
standby state.
•To enter standby mode, Touch and
hold the standby key for more than
3 seconds in the unlock sate. The
buzzer will beep and the display
board will show "--".
•To exit standby mode, Touch and
hold the standby key for more than
3 seconds in the unlock sate. The
buzzer rings will beep.
NOTE:
In standby mode, cooling will stop. If
you do not to use the appliance for a
long time, take out the wine, and
unplug the unit.
Light key
•When the door opened, the lighting
automatically lights up. The door
closed, and the lighting is delayed
for 30 seconds to turn off.
•After the door is opened, the lighting
can be turned on or off by touch the
light key.
•The brightness of the light can be
adjusted. Touch the light key for
approximately 3 seconds. to enter
the light brightness adjustment
mode, with 2 beeps. Touch the light
key to adjust the brightness of the
lighting according to the cycle of
high, medium, and low. Touch the
light key for approximately 3
seconds, or after 10 seconds of
keyless operation, or touch any key
except for the light key, will exit the
light brightness adjustment mode.
NOTE:
When the door remains open, the
light will automatically turn off after
a maximum of 10 minutes of
illumination.
21