Kübler Ants LES02 Manual De Instrucciones página 60

4 Installation
• Do not connect other users with high interference levels (such as frequency converters,
solenoid valves, contactors) to the power supply of the device.
NOTICE
4.1.6.1 Cable Bending Radius
R
min
ø d
For Shaft copying systems the following minimum values apply for cable outlet (R
Fixed installation
Flexible use
4.1.7 Step by Step Installation
The steps necessary for mounting the measuring system are represented as a succession of
pictures on the first pages of this operation manual, see Pictures [} 2].
The illustrations used for this purpose are examples intended to describe the operating
principle..
The following partial steps will lead to successful installation of the measuring system:
a) Analyze the construction plan and/or the shaft for the free run of the coded band and the
consistent sensor fastening on the car roof [} 2].
b) Mount the rail fastening flate in the shafthHead [} 2].
Secure the screws against loosening, see chapter Screw Retention [} 59].
c) Attach the carabiner and the coded band [} 3].
d) Uncoil the coded band up to the shaft pit [} 3].
e) Mount the rail fastening plate in the shaft pit [} 4]. Secure the screws against loosening,
see chapter Screw Retention [} 59].
f) Shorten the coded band to the required length, attach the carabiner and the securing band
to the tension spring and attach the tension spring [} 4].
g) Loosen the locking element and remove the front slide [} 5].
h) Insert the coded band and the slides and fasten the locking element [} 5].
i) Mount the sensor on the car fastening plate and mount the plate on the car roof . The
sensor must be mounted at a distance of about 50 mm from all moving parts [} 6].
j) Carry out the adjustment (e. g. with a short test travel) and tighten the screwed connections
[} 6]. Secure the screws against loosening, see chapter Screw Retention [} 59].
60 | EN
Maximum cable length
The maximum bus line must be designed according to the CAN
standard. An unreliable BUS connection leads to disturbances in the
safety application.
R
min
32 mm [1.26"]
64 mm [2.52"]
Operation Manual R60073.0009 - 03
Kübler Group
IMG-ID: 203527051
):
min